LATEST'S BREAKTHROUGH IN CERAMIC COATING Autotriz 3D Matrix Hybrid combines two of the greatest discoveries in science- Graphene and Polysilazane, to enhance the performance of nano coating. When Graphene is infused within the molecular structure of Polysilzane, its bonding strength and durability is greatly enhanced. Product Name: 3D Matrix Hybrid Description: Autotriz 3D Matrix Hybrid combines two of the greatest discoveries in science- Graphene and Polysilazane, to enhance the performance of nano coating. When Graphene is infused within the molecular structure of Polysilzane, its bonding strength and durability is greatly enhanced. 5 Years Coating Coverage: 3D Matrix Hybrid Coating is particularly suitable for car-painted surfaces, such as one (1K) or two-component (2K) paints (polyurethane or epoxy systems). The preferred use is for the exterior paint of cars, motorbikes, trucks, and buses. Per 50ML covers approximately 2 sedan cars. Instructions For Use Shake well before use.Get ready with 3 pieces of a brand new, lint-free microfiber towel. (It is recommended that new towels to be rinsed or washed with water prior to use to reduce the loosing lint)When first applying AUTOTRIZ 3D Matrix Hybrid Coating on a substrate, it is recommended to condition the surface of the applicator block with 7-8 drops to prevent skipping or dry spots.Do not work on a large area at a time. It is recommended to do a 2 ft. x 2 ft. area at a time.Apply AUTOTRIZ 3D Matrix Hybrid Coating using normal pressure on the applicator. Make sure the area is well covered. Always start from an edge to avoid excess on other panels. Work in controlled areas to remember where you previously applied. Work in horizontal or vertical movements to ensure that product is carried through consistently.Wait for 1-2 minutes. Use the first towel to level the product.Go immediately over with a second microfiber towel with a polishing motion until the surface is free from residue.Follow by the third towel (this is called the “insurance towel”) and go over the surface one extra time just to make sure you haven’t missed any streaks or excess residue just to make sure you haven’t missed any streaks or excess residue.When the whole car is applied, allow the curing of the coating to begin. Wait approximately 30-60 minutes before applying a second layer. For the ultimate in hydrophobic results and durability, it can be over-coated with AUTOTRIZ Top Coat.Curing times depend on temperature and humidity. Applying too early and the product will dissolve the previous layer. Allow curing of coating to begin. Curing can be accelerated using IR Lamps. Follow the lamp manufacturer's recommended settings.Keep coating away from all polish and compound dust during the curing process.INSPECTION LIGHTING SYSTEMLighting is of utmost importance during the application of a coating to paint. Spot Light like Scangrip is a good lighting system to inspect paint defects during polishing but in fact, it is NOT RECOMMENDED to use to check the residue of coating left on the paint. The suitable lighting system is Diffused Light. Precaution: Ensure the substrate is free from contaminants prior to and during the application process. Keep coating away from all polish and compound dust during the curing process. Process and Curing: The product must be applied at an ambient temperature of at least + 5°C and relative humidity of 30 % - 80 %. Avoid direct sunlight! Apply the coating in clean and dry conditions. Any mistakes can be rectified within approx. 10 min of application. Traces of water in the applicator should also be avoided. Applicators dampened with water should not be used. The applicators cannot be reused once the coating has been applied. 3D Matrix Hybrid Coating is dry-to-touch after about one hour.
