The VR probe is designed to allow technicians to input voltage from 0.5 volts up to 7 volts in 0.5 increments with only 1.5 amp output. This will allow technicians to be able to create the desired sensor signal with the correct voltage to components on the computer side without any worry of causing damage to the ECU. When using the VR probe in conjunction with a scope or scan tool you will be able to see if the correct voltage is being applied to that circuit/sensor and also if the component is being activated on the scope. You may also by-pass the component and send the desired voltage directly back to the ECU which will allow you to by-pass the sensor implying that the sensor is working and allowing you to remove the fault code. Designed to work on Acc pedal voltages 5V EGR signal voltage Diesel regulator value 1V Throttle Body Camshaft sensor Crankshaft sensor MAF MAP LIN lines for wipers Parking sensor Temperature sensor Oil pressure sensor Transducer based sensors Most sensors 5V and below The VR probe will eliminate the guess work when testing for faults and unnecessarily replacing components. Can be connected to 12V or 24V systems, the LED display indicated the vehicles voltage. The tool will also indicate low battery voltage.
