RC4WD 1/14 Scale RTR Earth Digger 360L Hydraulic Excavator – Yellow The Earth Digger 360L is a heavy-duty 1/14 hydraulic RC excavator built for experienced scale-construction operators. Its zinc-alloy and aluminum construction, 50 mm metal tracks, brushless hydraulic/drive systems and endless upper-structure rotation make it a substantial working machine rather than a display-only model. Construction & Scale Detail 1/14 scale hydraulic excavator Zinc-alloy and aluminum cast construction except hydraulic pump 50 mm wide zinc-alloy molded tracks Efficient metal undercarriage Powder-coated yellow and gray finish Scale driver-figure-ready cab; figure not included Preinstalled high-intensity light sockets; wiring and bulbs are not included Custom 8-channel 2.4GHz radio Hydraulic & Brushless Systems Optimized steel hydraulic system Reliable hydraulic valve and adjustable pump Heavy-duty hydraulic hose: 4.5 mm OD / 2.5 mm ID nylon Steel machined oil pump: 60 x 60 x 93 mm Hydraulic system: 60A brushless ESC Drive and rotation system: 30A brushless ESC 270KV brushless monster-torque motor with 3.0 mm shaft Operating oil pressure: 2.5 MPa XT60 female power connector Operating Functions Hydraulic boom up/down Hydraulic arm in/out Bucket curl/dump Independent tracked driving Endless 360-degree upper-structure rotation Combined proportional functions for realistic digging cycles Performance Digging force: 15 kg / 33 lb Maximum lifting force: 70 kg / 154 lb Driving speed: approximately 360 m/hour Typical runtime: approximately 20 minutes with a 4200mAh 11.1V battery, depending on operating load Dimensions & Weight Scale: 1:14 Length: 823 mm / 32.4 in Width: 234 mm / 9.21 in Height: 260 mm / 10.2 in Inside cab: 120 x 65 x 107 mm / 4.72 x 2.55 x 4.21 in Dead weight: 26 kg / 57 lb What's Included 1x RC4WD 1/14 Scale RTR Earth Digger 360L Hydraulic Excavator – Yellow Required to Complete 3S LiPo battery; RC4WD recommends 12V-class supply, 3S 25C, XT60 connector Battery dimensions must remain within approximately 160 x 51 x 73 mm Compatible LiPo charger 8x AA batteries for the radio AW ISO 32 hydraulic oil LiPo low-voltage alarm strongly recommended Optional Accessories Volvo decal sheet set — VVV-C0267 Cab window protective screens — VVV-S0186 Skeleton bucket — VVV-S0217 Narrow digging bucket — VVV-S0219 Wide bucket — VVV-S0218 Digging bucket — VVV-S0221 Quick Connect — VVV-S0220 Functional hydraulic radiator — VVV-S0246 Breaker / Hammer accessories — VVV-S0245 / VVV-S0244 Important Operating Notes For experienced RC hobbyists; RC4WD does not recommend this machine for users under 16. Turn on the transmitter before powering the excavator ESC. The excavator ships without hydraulic oil; fill the reservoir according to the manufacturer instructions before use. RC4WD's operating notes state that this unit does not have a low-voltage cutoff and recommend a LiPo low-voltage alarm to protect the battery. Inspect hardware after shipping and periodically during operation. Use quality hex drivers and thread lock sparingly where metal screws thread into metal. Do not over-tighten screws or adjust the factory oil-pressure setting. Avoid overheating the pump, hoses and electronics during extended operation. GASHEAD RC Owner Note At approximately 57 lb, the 360L should be planned around transport and service access before purchase. Use a sturdy loading surface, verify battery fit before ordering a pack, and inspect hydraulic fittings, track hardware and boom pivots after shipping. Because of the machine's mass and hydraulic power, controlled operation and preventative maintenance matter much more here than on a conventional electric crawler. SKU: VV-JD00016
Related