Full control over your Blumat system pressure. Adjustable from 2–14 PSI with a built-in gauge so you always know exactly what your system is running — the most important number to know in any Blumat setup. Key Features ＋ Built-in 0–30 PSI pressure gauge for real-time monitoring High flow rate of over 5 gallons per minute — can replace six or more standard Blumat pressure reducers Adjustable from 2–14 PSI to match any distribution method (drippers, drip rings, BluSoak) Powerful enough for the largest systems, precise enough for single-zone setups Connections & Adapters ＋ The reducer body has a ½" male pipe thread (MPT) inlet and a ¾" female pipe thread (FPT) outlet. Included adapters make it easy to install: Input — ¾" PVC swivel adapter for standard garden hoses or hose bibs Output — ¾" to ½" Perma-Loc fitting for Trunk Line Kits Output — ¾" to 8mm adapter for Supply Line Kits with SuperFlex tubing Also includes — ¾" FPT tee and 1/4" to ¾" MBT bushing Installation Instructions ＋ Tape all male fittings with the provided tape, wrapping 5–6 times clockwise. Assemble parts as pictured in the instruction diagram. Connect to a valve on a pump kit or to a hose bib using the provided ¾" swivel adapter. Using the provided fittings, connect to your Blumat system supply line. Open the incoming water to check current system pressure. Recommended ranges: Drip rings — 12–15 PSI BluSoak — 7–10 PSI To adjust pressure: turn off incoming water, release system pressure by opening a valve on the Blumat supply line until the gauge reads 0, then turn the black adjustment collar (tighten for more pressure, loosen for less). Close the Blumat supply line valve and open incoming water to re-pressurize. Check the gauge. If not in range, repeat steps 6–7 until correct.
Related
Related
Related
Related