This remote comes with easy programming instructions to make the system in your car accept this remote. Battery included. The number on the circuit board is AN20+AN07. The FCC ID on the back of the remote is ELVATRNA. The part number is 5BCR14SP. This remote has been tested to ensure it sends proper signals. We have free tech support to help you complete the programming. This remote is classified as an Audiovox Type 19 Transmitter. This means it can be used to replace or be replaced by other Type 19's like 175SPR,145SP 145SPR, 5BCR17SPR, 5BCR14RE. This remote was made for these Prestige and Pursuit Systems: APS997E, APS596E, PE2LCD. Programming Procedure: 1. Turn the ignition key to the on position. 2. Press and Release the Valet/Programming switch 3 times (Siren Chirps). 3. Press the Lock Button of each transmitter you want programmed until you hear a chirp from the horn or siren. 4. Turn the ignition switch off. The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons which are typical for most systems. For additional channel programming beyond the 1 option button, you can use any unused button or combination of buttons not in use. In other words, to access option channel 5, 6, 7, you would do the following: From step 3 above: a. Press and Release the Valet/Programming button 4 additional times to get to channel 5, then Press any unused transmitter button or button combination to program. b. From step a, Press and Release the Valet/Programming button 1 time to get to channel 6, then Press any unused transmitter button or button combination to program. c. From step b, Press and Release the Valet/Programming button 1 time to get to channel 7, then Press any unused transmitter button or button combination to program. NOTE: Not all systems have channels above 3, check with your installation center for options your system may or may not have. This remote has the ability to operate 2 Audiovox Alarms From A Single Transmitter. To toggle on and off vehicle one or two,,, Press the Trunk/Key button + the Lock button for 5 seconds. The LED flashes 2 times. Release the buttons, to select 2nd vehicle mode. Program this transmitter into the second vehicle's system. Any time you are in 2nd vehicle when the transmitter is operated, the LED will flash twice for each function. When in the prime vehicle mode, the LED will flash once for each function.
Related
Related
Related
Related