Omega called this remote part numbers that began with 110 and 210. The FCC ID of the remote is L2MAL41T. It has 2 buttons and transmits signals at 310MHz. We test the remote before sending it to you to ensure it is tranmitting proper signals. This remote was made for the followin Omega systems: C-2, C-2+, C-2+P, Freedom 150, Freedom 200, Freedom 200+, Freedom 200+P, and C-514. PROGRAMMING INSTRUCTIONS for C-2, C-2+, C-2+P, Freedom 150, Freedom 200, Freedom 200+, Freedom 200+P: Before you begin, your system must be in a disarmed state and you must know where your valet switch is located. Perform the following steps:1) Turn the vehicle's ignition to the "on" position2) Within 7 seconds of step 1, press the valet switch 5 times. The alarm should respond with a long siren chirp.3) Press the large/ lock button on your remote. The alarm should respond with a short siren chirp.4) Repeat step 3 for each additional remote that is to operate the system (up to 4 remotes). Note: the system will automatically exit programming mode if it detects a 15 second period of no activity PROGRAMMING INSTRUCTIONS for C-514: Before you begin, your system must be in a disarmed state. Perform the following steps:1) Turn the vehicle's ignition from "off" to "on" 5 times within 7 seconds. The system should respond with a horn honk or the door locks will lock then unlock.2) Press the large/ lock button on your remote. The system should respond with a short horn honk or the door locks will lock then unlock.3) Repeat step 2 for each additional remote that is to operate the system (up to 4 remotes).Note: the system will automatically exit programming mode if it detects a 15 second period of no activity
Related
Related