3 Pole Anderson Plug Surface Mount (DCDC) A clean, secure way to mount one 3 Pole Anderson-style plug on your canopy, tray, toolbox, caravan, camper trailer or 4WD setup. Designed for DCDC charger setups where positive, negative and ignition trigger wiring need to be grouped into one external plug connection. Ideal for keeping your DCDC wiring neat and easy to access, instead of having a loose plug hanging off a cable or cable-tied to your setup. Custom Label An optional front label can be added to identify the circuit. What's Included 1x 3 Pole Anderson Plug Surface Mount 1x Flexible TPU mounting gasket M5 countersunk stainless mounting hardware Note: Anderson plug and dust cover are sold separately. Made in Australia Designed and made in Australia by AFS Offroad from ASA-GF, a strong UV-resistant material suited to outdoor use. The included Flexible TPU mounting gasket is selected for flexibility, heat resistance, UV resistance and outdoor 4WD/canopy installs. What Plug Do I Need? This mount is designed for a 3 Pole Anderson-style plug, commonly used for positive, negative and ignition trigger wiring in DCDC charger setups. Plug type Typical use 3 Pole DCDC charger wiring with positive, negative and ignition trigger If unsure, match the mount to your existing plug, cable size and expected current draw. Key Features Designed around 3 Pole Anderson-style plug setups Extra cable clearance behind the plug Built-in dust cover cable cutout Optional front label to identify the circuit Clean rounded shape for a neat finished look Installation The countersunk mounting holes allow the mount to clamp down evenly over the gasket. Snug the screws down; no need to overtighten. View the Surface Mount Installation Guide. Backed by our 30-day change-of-mind returns, plus full cover for any fault under Australian Consumer Law. Important: water protection and electrical installation Not waterproof: Dust covers, mounting gaskets and connector mounts do not create a waterproof or watertight seal. Install them in a protected location away from direct spray, high-pressure water and immersion. Qualified installation required: All electrical wiring and installation must be carried out by a suitably qualified electrician or auto electrician, as appropriate. The installer must select correctly rated cable, terminals, fusing and circuit protection for the application.
