3 Pole + Anderson Plug Surface Mount (DCDC) A clean, secure way to mount one 3 Pole Anderson-style plug alongside one regular Anderson power plug on your canopy, tray, toolbox, caravan, camper trailer or 4WD setup. Designed for DCDC charger setups where positive, negative and ignition trigger wiring need to be grouped into one external plug, with a second Anderson connection for extra power. The first position is a 3 Pole plug. The second position is a regular Anderson plug in the size you choose. Custom Labels Optional front labels can be added to identify each circuit. What's Included 1x 3 Pole + Anderson Plug Surface Mount 1x Flexible TPU mounting gasket M5 countersunk stainless mounting hardware Note: Anderson plugs and dust covers are sold separately. Made in Australia Designed and made in Australia by AFS Offroad from ASA-GF, a strong UV-resistant material suited to outdoor use. The included Flexible TPU mounting gasket is selected for flexibility, heat resistance, UV resistance and outdoor 4WD/canopy installs. What Plug Do I Need? Position one is a 3 Pole plug, commonly used for positive, negative and ignition trigger wiring. Position two can be selected to suit SB50, SB120, SB175 or SB350 plugs. Plug type Typical use 3 Pole DCDC charger wiring with positive, negative and ignition trigger SB50 Fridge power, solar input, accessory power and lighter 12V circuits SB120 Battery charging, heavier canopy power and DCDC wiring where suitable SB175 Battery, inverter, trailer or higher-current auxiliary connections SB350 Very high-current charging, starting or equipment power setups If unsure, match the mount to your existing plug size, cable size and expected current draw. Key Features 3 Pole plug in position one, regular Anderson plug in position two Extra cable clearance behind the plugs Flexible TPU mounting gasket included Optional front labels to identify each circuit Clean rounded shape for a neat finished look Installation The countersunk mounting holes allow the mount to clamp down evenly over the gasket. Snug the screws down; no need to overtighten. View the Surface Mount Installation Guide. Backed by our 30-day change-of-mind returns, plus full cover for any fault under Australian Consumer Law. Important: water protection and electrical installation Not waterproof: Dust covers, mounting gaskets and connector mounts do not create a waterproof or watertight seal. Install them in a protected location away from direct spray, high-pressure water and immersion. Qualified installation required: All electrical wiring and installation must be carried out by a suitably qualified electrician or auto electrician, as appropriate. The installer must select correctly rated cable, terminals, fusing and circuit protection for the application.
