The most durable, reliable, and easy-to-service drip tape system we've ever offered. Pairs a preset 9" Blumat sensor with ultra-low-flow, 6-inch emitter spacing drip tape for uniform moisture across beds and large containers — without runoff, dry spots, or constant tuning. ⚠️ Not compatible with gravity systems — requires 10–15 PSI to operate correctly. Kit Options ＋ Container / Small Bed Kit (up to 2×4) For 30–90 gallon containers or beds up to 2×4 Two straight runs across the bed Includes 10 ft BluSoak drip tape and all fittings 4×4 Bed Kit Four straight runs across the bed Includes 20 ft BluSoak drip tape and all fittings 4×8 Bed Kit Four straight runs across the bed Includes 40 ft BluSoak drip tape and all fittings What's Included ＋ Preset 9" Blumat sensor BluSoak 3.0 drip tape with 6-inch emitter spacing (length based on kit) 8mm SuperFlex header lines All required BluSoak fittings What You'll Also Need ＋ This kit covers everything inside the bed. To complete your system you'll also need an 8mm supply line and a pressurized water source: 8mm Supply Line — runs from your water source to the sensor. See our 8mm SuperFlex Supply Line Kits. Pressurized Source (hose bib or pump) — requires a Pressure Reducer set to 10–15 PSI. Gravity systems will not work with this kit. Straight-Line Layout — Why It Matters ＋ Header-fed straight runs instead of a single woven piece makes a major difference between cycles: Lift the system out, amend your soil, drop it back in Easy reinstall without rebuilding Clean, modular layout with consistent pressure distribution Less frustration when turning over beds between runs What Makes BluSoak Different ＋ Lowest flow rate compatible with Blumat control 6-inch emitter spacing for continuous lateral wicking Uniform moisture distribution across the entire bed Thin-wall construction for easy cutting and installation The only tape we've found that consistently performs with pressurized Blumat systems Frequently Asked Questions ＋ Can I use this with a gravity system?No. These kits require 10–15 PSI and are designed for pressurized systems only. Why use straight lines instead of a woven layout?Straight-line layouts are modular and easy to remove, making them ideal for growers who re-amend soil between cycles. What makes this better than standard drip tape?Lower flow rate and tighter emitter spacing allow for even moisture distribution and proper compatibility with Blumat sensors. Do I need a pump?Yes, if running from a reservoir. A pressurized source is required.
