HDZero Whoop V2 VTX

Tiny Whoop Verified independent store

→

Here's the latest Whoop VTX from our pals at HDZero - capable of 90FPS! Here's what HDZero has to say about it: The HDZero Whoop V2 VTX is the evolution of the Whoop Lite VTX, desi gned for pilots who want the same HDZero performance, but with improved durability, reliability, and ease of installation. Supporting all HDZero MIPI cameras, including 540p90 , 720p60, and 1080p30 modes, the Whoop V2 delivers up to 200 mW of clean, low-latency HD video over 5.8 GHz. A thicker PCB provides greater impact resistance (addressing a common failure point of the Whoop Lite), a factory-soldered wire harness with Betaflight standard digital VTX plug simplifies installation, and a brass antenna retention bar keeps the U.FL connector secure through crashes and vibration. With its compact 31 × 31 mm footprint and 25.5 × 25.5 mm mounting pattern, the Whoop V2 fits everything from 80 mm whoops to 4-inch micro drones. For ultralight builds, our HDZero AIO boards combine FC + VTX with an AHD camera interface to save both weight and space. Power input range: 3 – 12.6 V (1S – 3S) Notes:• No reverse-polarity protection — incorrect wiring will permanently damage the unit.• Ensure ≥ 1.5 A available current when powered from a 5 V pad.• Direct 1 S power may dip below 3 V on throttle punch-outs, causing video loss.• External capacitor recommended for 3S setups. Includes M2 rubber grommets and a brass antenna bar for secure mounting. For high-speed racing, consider the HDZero Race V3 VTX which has a more common 20 x 20 mm mounting pattern for 5in builds. Specifications: Feature Whoop V2 VTX Whoop Lite VTX Comparison Supported Cameras All HDZero MIPI cams Video Resolution / Frame Rate 720p60 / 540p90 / 1080p30 RF Power Output 25 mW / 200 mW Frequency Range 5.725 – 5.850 GHz RF Connector Secured U.FL with brass bar Standard U.FL (no retention bar) Video Connector MIPI Durability / PCB Thicker PCB for impact resistance Thinner PCB – more prone to damage Wiring / Install Pre-soldered wire harness Manual soldering required Size 31 × 31 mm (29 × 29 inner) 32.5 × 32.5 mm (29 × 29 inner) Mounting Pattern 25.5 × 25.5 mm (M2) Weight 5.4 g (5.1 g w/o wires) 4.9 g (4.6 g w/o wires) Board Thickness ~1.6 mm ~1.2 mm (no shielding) Power Input 3 – 12.6 V (1S – 3S) Power Consumption 5 – 6 W Control / OSD MSP OSD / Smart Audio Recommended Use 80 mm whoops – 4″ micro drones 65 – 85 mm whoops Mounting Hardware M2 grommets + brass bar included M2 grommets only Antenna Included Not included Alternative for Ultralight Builds HDZero AIO (FC + VTX, AHD interface) Includes: HDZero Whoop V2 VTX * 1; Power/Uart Cable * 5； Zip ties * 2； Rubber Grommet (M3 to M2) * 4; u.FL Antenna Retention Screws * 3; Metal bar * 1 Show more