HDZero Whoop V2 VTX

Next FPV Verified independent store

→

The HDZero Whoop V2 VTX is the evolution of the Whoop Lite VTX, designed for pilots who want the same HDZero performance, but with improved durability, reliability, and ease of ins tallation. Supporting all HDZero MIPI cameras, including 540p90 , 720p60, and 1080p30 modes, the Whoop V2 delivers up to 200 mW of clean, low-latency HD video over 5.8 GHz. A thicker PCB provides greater impact resistance (addressing a common failure point of the Whoop Lite), a factory-soldered wire harness with Betaflight standard digital VTX plug simplifies installation, and a brass antenna retention bar keeps the U.FL connector secure through crashes and vibration. With its compact 31 × 31 mm footprint and 25.5 × 25.5 mm mounting pattern, the Whoop V2 fits everything from 80 mm whoops to 4-inch micro drones. For ultralight builds, our HDZero AIO boards combine FC + VTX with an AHD camera interface to save both weight and space. Complete your HDZero digital FPV setup by pairing the Whoop V2 VTX with the HDZero Goggles 2 for responsive, ultra-low-latency video. Power input range: 3 – 12.6 V (1S – 3S) Notes:• No reverse-polarity protection — incorrect wiring will permanently damage the unit.• Ensure ≥ 1.5 A available current when powered from a 5 V pad.• Direct 1 S power may dip below 3 V on throttle punch-outs, causing video loss.• External capacitor recommended for 3S setups. Includes M2 rubber grommets and a brass antenna bar for secure mounting. For high-speed racing, consider the HDZero Race V3 VTX which has a more common 20 x 20 mm mounting pattern for 5in builds. Specifications Feature Whoop V2 VTX Whoop Lite VTX Comparison Supported Cameras All HDZero MIPI cams Video Resolution 720p60 / 540p90 / 1080p30 RF Power Output 25 mW / 200 mW Frequency Range 5.725 – 5.850 GHz RF Connector Secured U.FL with brass bar Standard U.FL (no retention bar) Video Connector MIPI Durability / PCB Thicker PCB for impact resistance Thinner PCB – more prone to damage Wiring / Install Pre-soldered wire harness Manual soldering required Size 31 × 31 mm (29 × 29 inner) 32.5 × 32.5 mm (29 × 29 inner) Mounting Pattern 25.5 × 25.5 mm (M2) Weight 5.4 g 4.5 g Board Thickness ~1.6 mm ~1.2 mm (no shielding) Power Input 3 – 12.6 V (1S – 3S) Power Consumption 5 – 6 W Control / OSD MSP OSD / Smart Audio Recommended Use 80 mm whoops – 4″ micro drones 65 – 85 mm whoops Mounting Hardware M2 grommets + brass bar included M2 grommets only Antenna Included Not included Alternative for Ultralight Builds HDZero AIO (FC + VTX, AHD interface) Includes HDZero Whoop V2 VTX * 1; Power/Uart Cable * 5； Zip ties * 2； Rubber Grommet (M3 to M2) * 4; u.FL Antenna Retention Screws * 3; Metal bar * 1 Show more