iBMS: Interface for BMS Your browser does not support our video. Isolated CAN1/2 for use with Multiple iBMSNote: Not suitable for multiple linked JK-BMS PB(Inverter) please use our iBMS for JK-BMS PB Series(Inverter) board.These boards require 1 board per BMS, and can be linked with other iBMS boards eg JK, JBD, CAN Battery. This all new Interface is designed with many features: Updated design specifically for Muli-BMS use with Isolated CAN1/2 ports, dedicated Isolated CAN Power supply and new Isolated CAN driver with +-70 bus fault protection. Supports Most Inverters with CAN communications, profiles for: BYD, Deye, Generic, Goodwe, Pylon, LIA (beta), Victron: with Type A cable New iBMS firmware completely written in esp-idf using 100% my own code, no more esp-home. Optional support for Victron Smart Shunt for more accurate SOC, you need to also order the Smart Shunt Connection kit New companion Home Assistant integration(custom component must be installed) Web page designed for mobile phone size screens The one board can be used with a standalone battery or used in a multi BMS setup, software configurable as a Master or Slave(1-9). One board needed per BMS Future proof, can be used with the original JK-BMS or the new Inverter type.One board to rule them all. DIP switches to enable CAN termination. Improved CAN bus driver chip TVS Transient voltage suppression, to protect the CAN driver chip. On board buck converter with resettable fuse. The original JK-BMS with the 4 pin connecter supplies power to board, plug and play. Note: Inverter type, must be powered direct from battery 12-60v, with the included cable. 2 temperature sensors displayed with newer JK-BMS. Professionally manufactured and burn in testing. Lead free construction, greener and low environmental impact! Supports most of the original JK-BMS models with the small 4 pin GPS connector eg:JK-BD6A17S6P/ JK-BD6A20S6P / JK-BD6A24S6P / JK-BD6A20S10P / JK-B1A20S15P / JK-B1A24S15P / JK-B2A8S20P / JK-B2A20S20P / JK-BD2A24S20P / JK-B2A25SRPPlease add cable to your cart, needed for the Original JK-BMS, see below!1 x 4 pin JST 30cm cable for the original JK-BMSSupports inverter models:JK-PB1A16S10P / JK-PB1A16S15P / JK-PB2A16S15P / JK-PB1A16S20P / JK-PB2A16S20P Hardware connectors:1x 4 Pin JST connector for original JK-BMS1 x RJ45 RS485 for connection to JK-BMS RS485-1 (beside CAN port)2 x RJ45 CAN Isolated for connection to Inverter/slavesWhat's included:1 x iBMS interface board1 x 2 pin power 30cm cable for use with newer inverter type.1 x Digital download of instructions and our Home Assistant integration Optional add to cart see below:1 x 4 pin JST 30cm cable for the original B JK-BMS
