Open Mesh GRP Grating - 50mm Thick A heavy-duty composite floor grating moulded from GRP (glass reinforced polyester) with a resin-coated gritted surface. Each 3660mm x 1220mm sheet is 50mm thick, non-conductive and resistant to chemicals, rust and corrosion - a lighter, longer-lasting alternative to steel or timber for walkways, platforms and covers. Available in green, grey or yellow. Key features Gritted anti-slip surface, pendulum tested to BS7976-2 - coefficient of friction 72 dry, 68 wet, 63 in oil Non-conductive, including around HV electrical equipment Chemical, rust and corrosion resistant with a design life of more than 10 years Load rated to BS EN 124 Class A15 and fire rated to BS 476 Part 7 Class 2 Suitable for heavy footfall and wheeled traffic, indoors or out, from -50°C to +110°C Cut to size in house to a +/- 5mm tolerance, or trim on site with a hacksaw or jigsaw Where it is used Walkways and platforms on industrial and construction sites Ramps, access ways and covers Chemical plants and processing areas Shipping, marine and offshore installations, including oil rigs Sizes and colours Each sheet is 3660mm x 1220mm and 50mm thick, in a choice of green, grey or yellow. The same grating is also available in 25mm and 38mm thicknesses, sold separately, and the matching fixing clips and clamps are listed as accessories. Fitting and upkeep Panels are secured with the separate M clips, C clips, J clamps or 45mm square fixing clips. Day-to-day cleaning needs only a stiff brush; use warm water and mild detergent on stubborn dirt, or a pressure washer on a low setting. Inspect the grating periodically to check the fixings remain firm. Specification Material GRP - glass reinforced polyester with a resin-coated gritted surface Thickness 50mm Sheet size 3660mm x 1220mm Colours Green, grey or yellow Slip resistance BS7976-2 pendulum tested; coefficient of friction 72 dry, 68 wet, 63 oil Load rating BS EN 124 Class A15 Fire rating BS 476 Part 7 Class 2 (standard ISO resin); ASTM-E84 flame spread 25 UV resistance ISO 4892-2 xenon arc, 5,000 hours Temperature range -50°C to +110°C Electrical Non-conductive, including HV Environment Indoor and outdoor use Design life Over 10 years Cutting tolerance +/- 5mm Customisation Bespoke sizes are supplied through our in-house cutting service, and custom colours may be available on request - contact us to discuss your requirements.
