We are sweetening up your gym once again with our new vertical barbell hanger. This bar storage is made in the USA from 0.1875" thick laser cut steel with protective UMHW plastic to protect your bars and secure them off the floor. The unique Plate Snacks drip design will add some flair to your gym while adding additional storage and versatility. Available in Bright Pink and Clear Coat powder coat. Fits the majority of 25mm-32mm olympic barbells. Hardware Included: Pair of 3/8 x 2" lag screws and 5/16" washers to mount holder to stringer. Note: Axel Bars and certain specialty bars may not properly fit or sit well on the hanger. Dimensions: Width: 12" Height: 8.5" (At tallest point) Depth: 4" Weight: 5lbs 11oz Hanging Instructions: 1) Find the studs on your wall (usually 16" apart) 2) Hang a stringer (piece of wood) spanning across two of the studs and securely screw in with screws. Make sure it is level prior to screwing the second side 3) Take the barbell hanger and place it against the stringer and mark the board through the mounting holes. 4) It is best practice to secure a stringer to the studs. 5) Once the stringer is secured to the wall, you can mount your barbell hanger to the stringer using the mounting holes. Adjust to ensure the hanger is level. *If your stringer is thinner than a 2x4, the provided screws may be too long.
