The HDZero Whoop V2 VTX is the evolution of the Whoop Lite VTX, designed for pilots who want the same HDZero performance, but with improved durability, reliability, and ease of installation. Supporting all HDZero MIPI cameras, including 540p90 , 720p60, and 1080p30 modes, the Whoop V2 delivers up to 200 mW of clean, low-latency HD video over 5.8 GHz. A thicker PCB provides greater impact resistance (addressing a common failure point of the Whoop Lite), a factory-soldered wire harness with Betaflight standard digital VTX plug simplifies installation, and a brass antenna retention bar keeps the U.FL connector secure through crashes and vibration. With its compact 31 × 31 mm footprint and 25.5 × 25.5 mm mounting pattern, the Whoop V2 fits everything from 80 mm whoops to 4-inch micro drones. For ultralight builds, our HDZero AIO boards combine FC + VTX with an AHD camera interface to save both weight and space. Power input range: 3 – 12.6 V (1S – 3S) Note No reverse-polarity protection — incorrect wiring will permanently damage the unit. Ensure ≥ 1.5 A available current when powered from a 5 V pad. Direct 1 S power may dip below 3 V on throttle punch-outs, causing video loss. External capacitor recommended for 3S setups. Includes M2 rubber grommets and a brass antenna bar for secure mounting. For high-speed racing, consider the HDZero Race V3 VTX which has a more common 20 x 20 mm mounting pattern for 5in builds. Specifications General Supports all HDZero MIPI cameras Video resolutions: 720p60, 540p90, 1080p30 RF output power: 25 mW / 200 mW Frequency range: 5.725 – 5.850 GHz Hardware & Build Secured U.FL connector with brass retention bar MIPI video connector Thicker PCB for better durability and impact resistance Pre-soldered wire harness (easy installation) Board thickness: ~1.6 mm No antenna included Size & Mounting Size: 31 × 31 mm (29 × 29 mm inner) Mounting pattern: 25.5 × 25.5 mm (M2) Weight: 5.4 g Power & Control Input voltage: 3 – 12.6 V (1S – 3S) Consumption: 5 – 6 W Supports MSP OSD and Smart Audio Comparison V2 Lite RF Connector Secured U.FL + brass retention bar Standard U.FL (no retention bar) Durability Thicker PCB, more impact-resistant Thinner PCB, more prone to damage Wiring/Installation Pre-soldered wire harness Requires manual soldering Size 31 × 31 mm (29 × 29 inner) 32.5 × 32.5 mm (29 × 29 inner) Mounting Pattern 25.5 × 25.5 mm (M2) Same pattern Weight 5.4 g 4.5 g (lighter) Board Thickness ~1.6 mm ~1.2 mm (no shielding) Recommended Use 80 mm whoops up to 4″ micro drones 65–85 mm whoops Includes 1x HDZero Whoop V2 VTX 5x Power/Uart Cable 2x Zip ties 4x Rubber Grommet (M3 to M2) 3x u.FL Antenna Retention Screws 1x Metal bar Browse more Browse all HDZero Browse all Shark Byte
Related
Related
Related
Related