Are you looking to buy a Matek F405-MiniTE Flite Controller in Australia? The new features of F405-miniTE compared with F722-miniSE(EOL) F405 has 1MB flash which can run with ArduPilot. even with INAV firmware, some features will be removed on F722 due to limited flash. The advantage of F722 is all UARTs have builtin inversion which is not needed when CRSF protocol is widely used on new receivers. Redesigned target MATEKF405TE support 8x bi-directional DSHOT. Support DJI air unit PnP, and a 10V BEC for DJI OSD or analog VTX Compared with F722-miniSE 8motors or 6motor+2servos, F405-miniTE support 8motors+3servos in INAV/BF multirotor mixer InvenSense GEN3 IMU ICM42605 FC Specifications MCU: STM32F405RGT6 IMU: ICM42605 OSD: AT7456E Baro: Goertek SPL06-001 (I2C) Blackbox: 16M-byte Flash memory 6x UARTs, 1x Softserial_Tx option 12x PWM outputs (8x Dshot) 1x I2C 4x ADC (VBAT, Current, RSSI, Airspeed) 2x PINIO 1x SH1.0_8pin connector (Vbat/G/Curr/R3/S1/S2/S3/S4) 1x SH1.0_6pin connector for DJI FPV Air Unit 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red) Dual BEC, 5V 1.7A & 10V 1.4A 10V output ON/OFF switchable Convertible 20mm to 30.5mm mounting Power Input: 6~30V (2~S LiPo) BEC: 5V 1.7A, Max.2A BEC: 10V 1.4A for VTX or DJI Air Unit Battery Voltage Sensor: 1K:20K (INAV scale 2100, BF scale 210) No Current Sensor built-in, supports external current sensor of PDB/4in1 Firmware ArduPilot: MatekF405-TE INAV: MATEKF405TE BetaFlight: MATEKF405TE Physical Mounting 20 x 20mm/Φ3mm with Silicon Grommets 20 x 20mm/Φ2mm with Silicon & Brass Grommets 30.5 x 30.5mm/Φ3mm with Conversion Plate and Silicon Grommets Dimensions: 28 x 28 mm Weight: 5g Including 1x FC F405-miniTE 1x 20mm to 30.5mm conversion plate(blue PCB) 6x Silicon grommets M4 to M3 6x Brass grommets M3 to M2 1x SH1.0_8pin cable 5cm (including 2x 8pin connectors) for 4in1 ESC 1x SH1.0_6pin to GH1.25_8pin cable 8cm for DJI Air Unit Browse more Browse all Matek Flight Controllers Browse all F4 Flight Controllers Browse all Flight Controllers
